Centre Punch Buyers Guide
From DT Online
- All punches shown have a good knurled grip.
- Those with a square head are less likely to roll off the bench.
- The specialised 'bell' centre punch is used to mark the centres on the end of round bars and can be used as an alternative to Centre Drilling on a lathe.
|Stanley Centre Punch 0 58 120||Draper 84456 4mmx100mm Centre Punch||Starrett 117D Centre Punch with Round Shank||Spear & Jackson 4mm x 100mm (4inch) Centre Punch||RDGTOOLS Engineers Bell Punch "Centre find every time"|