Actions

Centre Punch

From DT Online

The printable version is no longer supported and may have rendering errors. Please update your browser bookmarks and please use the default browser print function instead.
CentrePunch.png


Description

Centre Punches are ground to a strong point with an included angle of 90 degrees by holding them Tangentially to a Tool Grinder and rotating them. This tends to create grinding marks which run along the point and strengthen it rather than weakening it by going across (i.e. in a similar manner to a Scriber).


Features and Uses

To stop a drill bit skidding about a metal surface, these are used to make a small indentation to locate the drill centre.


Note: Hold the punch to an angle to position on centre then raise to the vertical and strike it sharply with a hammer - but only once - striking several times may cause the punch to bounce around.


DT Online Buyers' Guide
  • The lowest cost option is to use a hand-held punch with a hammer but a wide range of automatic punches are available - both Dot Punches and Centre Punches.
  • In general, Dot Punches have a sharper point (i.e. 60° instead of 90°) and need only the lower ranges of impact force (e.g. 20N to 50N).
  • Automatic punches are simply pushed down against the work-piece and do not need to be struck - indeed, should NOT be struck with a hammer.
Centre Punch Automatic Centre Punch Bell Centre Punch Nail Punch Pin Punch Hollow Punch Set Number and Letter Punch Set
Centre Punch Automatic Centre Punch Bell Centre Punch Nail Punch Pin Punch Hollow Punch Set Number and Letter Punch Set