Dot Punch

Description

Dot Punches are similar to Centre Punches but have a sharper point by being ground to an angle of 60 degrees (in a similar manner to a Scriber).

Features and Uses

Dot Punches are held at an angle to the intersection or line to be marked and either lightly struck once with a hammer. Alternatively, Automatic Dot Punches are available, as shown, which are simply pushed down to activate.

---

Note:

If Dot Punches are used to mark where a large hole crosses each of its centre lines, for instance, accurate work would result in each ‘dot’ being halved across its diameter.

---

DT Online Buyers' Guide

The lowest cost option is to use a hand-held punch with a hammer but a wide range of automatic punches are available - both Dot Punches and Centre Punches.

• In general, Dot Punches have a sharper point (i.e. 60° instead of 90°) and need only the lower ranges of impact force (e.g. 20N to 50N).
• Automatic punches are simply pushed down against the work-piece and do not need to be struck - indeed, should NOT be struck with a hammer.