Difference between revisions of "Half Moon Stake"
From DT Online
|Line 5:||Line 5:|
They can be used generally in '''[[:Category:Beaten Metalwork|Beaten Metalwork]]''' but in '''[[:Category:
They can be used generally in '''[[:Category:Beaten Metalwork|Beaten Metalwork]]''' but in '''[[:Category:|Tinsmithing]]''' can be used during the first stages of folding over the edge of a disc of '''Tinplate''' to create a base with a '''[[Knocked Up Joint]]''' for example.
|Line 13:||Line 13:|
Latest revision as of 17:26, 28 May 2017
A Half Moon Stakes are so named because of their obvious shape.
They can be used generally in Beaten Metalwork but in Tinsmithing can be used during the first stages of folding over the edge of a disc of Tinplate to create a base with a Knocked Up Joint for example.
- Traditional Boxwood Mallets are now largely superceded by Nylon, PVC or rubber faced hammers and mallets for general work. They are available in a range of diameters and weights.
- Carpenters' Mallets with a head size of 4-5 inches (100mm - 125mm) are a suitable size for most work in Design and Technology.
- Carving Mallet heads are commonly made from Beech but Lignum Vitea heads are considered better because they are heavier. They may now be hard to find. A modern alternative is to use Polyurethane for the heads (Bronze or Brass also used). A good general size head weight for light work would be approximately 450 grams or less, and for general work, 800 grams is more suitable.
- Bossing Mallets are sized by head diameter (35, 50, 60, or 75mm). The smaller sizes are used for art metalwork and the larger sizes are for shaping and stretching sheet metal and soft roofing materials such as lead.
|Nylon Hammer||Rubber Mallet||Carpenters Mallet||Carvers Mallet||Rawhide Mallet|