Keys, Keyways and Splines
From DT Online
Revision as of 15:11, 14 May 2016 by DT Online (Corrected Link)
This can be achieved by making the hole a very tight fit on the shaft (known to Engineers and Mechanics as a Press Fit or Interference Fit) but this is not suitable if the component has to be removable.
Note: When making simple working models in wood, drilling a tight size hole or even gluing is usually sufficient
Note: When using Grub Screws a better grip can be achieved if two are used but these must be positioned at 90° to each other. Alternatively, the screw can be tightened on to a 'flat' which has been filed or milled on to the shaft.
|Use of Grub Screws on a Plain Shaft||This is a relatively straightforward means of attaching components to shafts suitable for light to moderate loading. It requires no special tooling needing only holes to be drilled and tapped into the body of the component.|
|Grub Screw mated on to a ‘Flat’||Screws located on to a ‘flat’ can increase the resistance to slippage and help align components along a shaft.|
|Use of a Squared Shaft||Suitable only where a component is fitted at the end of a shaft but capable of transmitting very high loads and provides a positive location of the component in one of four positions.|
|Feather Key (aka Flat Key)||These can be used at any point along the shaft to provide a very positive location and capable of transmitting high loads (may need spacers or the presence of other components to prevent movement along the axis of the shaft). The Keyway can be cut using a End Mill.|
|Woodruff Key||In common use on tapered shafts because they can tilt to accommodate the taper angle. The Keyway is cut using a Woodruff Cutter in a Milling Machine.|
|Gib Head Key||Useful when component are fitted at the end of a shaft which may need to be removed easily - the key is removed by striking a wedge-shaped drift between the head and the component. The Keyway can be cut using a Milling Machine with a Side and Face Cutter or a Slitting Saw.|
|Use of Drilled Holes and Pegs||A relatively simple way of providing a key-type location is to drill axially down the joint between component and shaft then inserting small rods as shown.|
|Splined Shaft||In common use in car gearboxes and also the main transmission shaft which has to be telescopic to allow for the movement of car supension.|