Actions

Knocked Up Joint

From DT Online

Revision as of 09:11, 28 February 2018 by DT Online (talk | contribs)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Description

A Knocked Up Joint or Double Seam is commonly used to fix an end to a cannister or food can. The canning industry would normally use a Seaming Machine (see A Dash of Science for further detail) but they were traditionally hand made by Tinsmiths. If made properly a Knocked Up Joint should be water-tight without being soldered but, of course, they can be soldered as well if required.


Making the Joint
TinsmithMakingStandingSeam.png
  • To make the base, mark out a circle with its radius equal to the cylinder radius plus twice the width of the Seam.
  • Form a rim round its outside with a depth equal to the width of the Seam (do this by working around the circumference little by little with Flat Nosed Pliers and truing up with a Boxwood or Rawhide Mallet on a Mandrel Stake).
  • The length of the cannister needs to be extended by the width of the Seam so that a flange equal to this can be formed around one end (as before, do this by working around the end little by little with Flat Nosed Pliers and truing up with a Boxwood or Rawhide Mallet on a Bench Block, Tinman's Anvil or similar flat surface).


TinsmithMakingKnockedUpJoint.png
  • Place the flanged cannister inside the rim of the base and flatten the rim down on to it using a Boxwood or Rawhide Mallet down on to a Bench Block or similar surface.
  • The joint formed at this stage is known as a Paned Down Seam
  • To complete the Knocked Up Joint or Double Seam, the cannister is held on to a Mandrel Stake and folded over again as shown.

Note: Use a Mallet and not a Hammer to avoid stretching the metal as it is struck (this would cause the edge to distort).



DT Online Buyers' Guide
Soft Faced Hammers Tin Snips Bench Shears 240v Shears/Nibbler Cordless Shears/Nibbler Bench Folder Panel Flanging/Joggler Tool Solid Steel Bench Block Step Drill Set Clarke Spot Welder Rolling Mill


Soft Faced Hammers Tin Snips Bench Shears 240v Shears/Nibbler Cordless Shears/Nibbler Bench Folder Panel Flanging/Joggler Tool Solid Steel Bench Block Step Drill Set Clarke Spot Welder Rolling Mill



Self Tapping Screws Hex Head Stitching Screw Spire Clips Pop Rivets Rivetnuts
Self Tapping Screws Hex Head Stitching Screw Spire Clips Pop Rivets Rivetnuts