Actions

Mortiser: Difference between revisions

From DT Online

m (Corrected Link)
m (Corrected Link)
Line 16: Line 16:


<span style="color: green">'''Note:'''
<span style="color: green">'''Note:'''
Many '''[[Mortice and Tenon Joint|Mortice and Tenon]]''' joints in furniture production today are probably cut by a '''[[CNC Router]]'''. The evidence of this can be seen if the mortice has rounded ends.
Many '''[[Mortise and Tenon Joint|Mortise and Tenon]]''' joints in furniture production today are probably cut by a '''[[CNC Router]]'''. The evidence of this can be seen if the mortice has rounded ends.
----
----
</span>
</span>

Revision as of 09:20, 8 February 2016

BenchMountedMortiser.png


The Hollow Chisel Mortiser was invented in 1874 by the twin brothers Robert and Ralph Greenlee, founders of the Greenlee Company. Both floor-mounted and bench-mouned models are available.


The square chisels used are sharpened square tubes inside which an Auger Bit revolves to remove the bulk of the waste as the chisel is pressed into the workpiece. Although this can be quite slow for production work, the hollow chisel is easy to change when different size mortises are needed making them ideal for small scale furniture production.


A Mortising Attachment can usually be fitted to a Drill Press and for occasional use by an individual, this avoids the cost of an additional machine. The cutting tool (i.e. the Auger Bit) is almost completely enclosed within the hollow chisel making them relatively safe to use.


An alternative for heavier work is a Chain Mortiser but the mortise they cut can have rough edges where the chain exits the mortise so they are not suitable for fine furniture making. They are similar in operation to a Chain Saw and not recommended for use in schools.


Note: Many Mortise and Tenon joints in furniture production today are probably cut by a CNC Router. The evidence of this can be seen if the mortice has rounded ends.