View source for BFY51 Transistor

[[File:BFY51.png|250px|right]]
__TOC__


=====Description=====

A  '''BFY51''' Transistor is an '''NPN''' ''(Negative-Positive-Negative)'' [https://en.wikipedia.org/wiki/Bipolar_junction_transistor#NPN '''Bipolar Transistor''']: the most commonly used transistor configuration


The '''BFY51''' Collector is connected to the positive (+ve) supply via the load. NB If the load is inductive i.e. has coil windings such as a relay, solenoid or motor, then it is usual to connect a diode across it to prevent the Back EMF from damaging the transistor. (Cathode to supply). The input is connected to the Base via a limiting resistor (typically 1K). The Emitter is connected to the negative (-ve) supply (0V).


=====Features and Applications=====

'''Uses:''' As current amplifiers and electronic switches, for example, Motor Drive Amplifiers, Audio Amplifiers.


'''Data:''' Voltage between Collector and Emitter 6 - 30Volts max.
* Power handling capacity 800mWatts max.
* Current handling capacity 1 Amp max.
* Amplification (gain) greater than 50.

----
<span style="color: green">'''Note:'''
Older Transistors such BFY51 may sometimes be difficult to obtain but 2N3053 is a good substitute ''(i.e. it is NPN, can operate with similar voltage and current and has the same TO-5 metal case and pin-out)''.  BC548B is a another, lower power, equivalent with a TO-92 plastic case but many others exist and can be found in transistor equivalents tables).
</span>
----


=====Single Transistor Switch=====
[[File: SingleTransistorSwitch.png|200px|right]]


The transistor is often used as a switch in electronic circuits. A signal of 0.6V, or greater, to the '''BASE''' of the transistor "switches on" the component and allows a current to flow in the '''COLLECTOR / EMITTER''' circuit.


Transistors also act as '''CURRENT AMPLIFIERS''' since a small base current '''(Ib)''' controls a much larger collector current '''(Ic)'''. The amplification '''(GAIN - hfe)''' of a transistor, is given by the equation '''hfe = Ic/Ib''' and is typically several hundreds.


The purpose of the  '''IN4001 [[Diode]]''' shown is to restrict any [https://en.wikipedia.org/wiki/Counter-electromotive_force '''Back EMF'''] resulting from the Transistor being used to switch an inductive device ''(e.g. '''[[Electric Motor]]''', '''[[Solenoid]]''' or '''[[Relays|Relay]]''').

----
<span style="color: green">'''Note:'''</span>
* <span style="color: green">When choosing a transistor it is important to make sure that the gain is high enough for the required use and that the maximum current which it can handle is sufficient to drive the output device. e.g. BFY 51 gain > 40 , max Ic = 1 amp.</span>
* <span style="color: green">If the max Ic value is exceeded, the transistor will probably "burn out".</span>
* <span style="color: green">The transistor acts as a '''NOT''' gate ''(inverter)'' since a "high" at the base gives a "low" at the collector. ''(i.e. when the transistor switches on, the collector voltage decreases).''</span>
----


{{Transistor & IC Buyers Guide}}


[[Category:Secondary]]
[[Category:Electronics Components]]