Hollow Punch: Difference between revisions
From DT Online
(Created article) |
(Added Template) |
||
(4 intermediate revisions by 2 users not shown) | |||
Line 1: | Line 1: | ||
[[File:HolePunch.png|300px|right]] | [[File:HolePunch.png|300px|right]] | ||
__TOC__ | __TOC__ | ||
=====Description===== | |||
[https://en.wikipedia.org/wiki/Leather_punch '''Hollow Punches'''] are sharpened lengths of tube which are struck with a hammer against a firm surface. | |||
=====Uses===== | =====Features and Uses===== | ||
These are struck with a '''[[:Category:Hammers|hammer]]''' to cut holes in most compliant materials ''(e.g. paper, card, leather, textiles)''. | These are struck with a '''[[:Category:Hammers|hammer]]''' to cut holes in most compliant materials ''(e.g. paper, card, leather, textiles)''. | ||
---- | ---- | ||
Line 13: | Line 12: | ||
</span> | </span> | ||
---- | ---- | ||
{ | {{Hollow Punch Buyers Guide}} | ||
[[Category:Punches]] | [[Category:Punches]] |
Latest revision as of 12:33, 15 May 2016
Description
Hollow Punches are sharpened lengths of tube which are struck with a hammer against a firm surface.
Features and Uses
These are struck with a hammer to cut holes in most compliant materials (e.g. paper, card, leather, textiles).
Note: Place a piece of scrap wood, or MDF under the material to be cut and use on a sturdy bench top or similar worksurface.
- The lowest cost option is to use a hand-held punch with a hammer but a wide range of automatic punches are available - both Dot Punches and Centre Punches.
- In general, Dot Punches have a sharper point (i.e. 60° instead of 90°) and need only the lower ranges of impact force (e.g. 20N to 50N).
- Automatic punches are simply pushed down against the work-piece and do not need to be struck - indeed, should NOT be struck with a hammer.
Centre Punch | Automatic Centre Punch | Bell Centre Punch | Nail Punch | Pin Punch | Hollow Punch Set | Number and Letter Punch Set |