Scoring and Creasing: Difference between revisions
From DT Online
(Scoring and Creasing) |
(Added Template) |
||
| (4 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
[[File:ScoringCard.jpg| | [[File:ScoringCard.jpg|400px|right]] | ||
__TOC__ | |||
=====Description===== | |||
Sheet materials may be scored or creased to make folding easier - and more accurate. '''Scoring''' is the process of scribing, or even partly cutting through, the material along the line to be bent or folded. | Sheet materials may be scored or creased to make folding easier - and more accurate. '''Scoring''' is the process of scribing, or even partly cutting through, the material along the line to be bent or folded. | ||
| Line 13: | Line 18: | ||
---- | ---- | ||
'''Creasing''' is similar to scoring but the surface is compressed rather than cut. It is a good way of preparing soft materials such as card for folding and can be done using an empty [http://en.wikipedia.org/wiki/Ballpoint_pen Biro] or the back edge of a pair of scissors. | '''Creasing''' is similar to scoring but the surface is compressed rather than cut. It is a good way of preparing soft materials such as card for folding and can be done using an empty [http://en.wikipedia.org/wiki/Ballpoint_pen Biro] or the back edge of a pair of scissors. | ||
{{Paper and Card Buyers Guide}} | |||
[[Category:Primary]] | |||
[[Category:Secondary]] | |||
[[Category:Graphics and Modelling Techniques]] | |||
Latest revision as of 19:42, 5 July 2016
Description
Sheet materials may be scored or creased to make folding easier - and more accurate. Scoring is the process of scribing, or even partly cutting through, the material along the line to be bent or folded.
When working with card, this can be done using a pair of scissors but thicker sheets may need to be partly cut through with a craft knife.
Safety Point! Always use a Craft Knife together with a Safety Ruler and Cutting Mat to protect fingers and table tops.
Note: Scoring or scribing cuts or scratches the surface of material. This can create a stress concentration and be a potential failure point. Scribed lines on soft metals such as Aluminium should therefore be placed on the inside of a bend where they will be closed up.
Creasing is similar to scoring but the surface is compressed rather than cut. It is a good way of preparing soft materials such as card for folding and can be done using an empty Biro or the back edge of a pair of scissors.
 
|
|
|
|
|
|
|
|
|
|
|
| A3 Landscape Sketch Pad
|
A4 File Paper
|
Squared Pattern Tracing Paper
|
A3 Graph Pad
|
Coloured Card
|
A2 White Card
|
A1 White Cartridge Card
|
A2 Kraft Card
|
Grey Board
|
A2 Mount Board
|
Corrugated Card
|