Box Modelling: Difference between revisions
From DT Online
(Added Template) |
m (Added Category) |
||
| Line 55: | Line 55: | ||
[[Category:Graphics and Modelling Techniques]] | [[Category:Graphics and Modelling Techniques]] | ||
[[Category:Stripwood Technology]] | [[Category:Stripwood Technology]] | ||
[[Category:Skills and Processes]] | |||
Revision as of 16:35, 16 September 2017
Modelling with 'found objects' is familiar to all young children and might also be called 'junk modelling'. But this not a term used within this web site because even models made with 'found objects' can be quality items - not 'junk' at all!
Description
Used cartons can be taken apart and turned inside out to create a box with a clean, unpainted surface that will accept PVA Glue and water-based paint very well. The boxes can be re-sealed using double-sided tape or a Glue Gun.
Features and Uses
Safety Point! Glue Guns, even so-called low melt ones, squeeze out very hot plastic glue which can cause severe burns. Use only with great care and with adult supervision.
Many will be familiar with dried water-based paint soon flaking off if applied to the normal outside surface. This is because the surface is no longer porous and may even be laminated with a thin coating of plastic.
Clean card tubes, from kitchen rolls for example, are another good source of material for Box Modelling. They also can be glued with PVA Glue and painted easily.
Boxes can be reinforced, or more detail added, by using PVA to glue on strips of clean, bare wood. This is also a porous material and will accept glue or paint well.
Adding such detail can provide mounting points for an Electric Motor or could transform a simple box into a model of a half-timbered medieval building for example.
Holes can be pushed into a card box with a pencil then made into neat bearings for axles by gluing over them a piece of card with a hole made by a Paper Punch.
Tubes or thin strips of wood can be cut to length using a Junior Hacksaw.
Safety Point!
Junior Hacksaws are safe for even quite young children, provided the work is firmly held and a metal cutting blade is used - their teeth are too small to cause real harm, they require least effort to push through the material and do not jam against edges of timber for example.
Wood strips can be held securely using a small clamp-on metalwork vice. Older children may be able to cope with a junior Bench Hook held against the worktable edge.
Safety Point! Take great care with hot glue guns and all hot-melt glues. The melted glue can stick to the skin and cause severe burns.
