Centre Punch: Difference between revisions
From DT Online
mNo edit summary |
m (Added Amazon Link) |
||
| (5 intermediate revisions by 2 users not shown) | |||
| Line 1: | Line 1: | ||
<div class="floatright"><dtamazon type="search" search="Centre Punch"><img alt="CentrePunch.png" src="/images/thumb/c/c2/CentrePunch.png/300px-CentrePunch.png" width="300" height="256" srcset="/images/c/c2/CentrePunch.png 1.5x, /images/c/c2/CentrePunch.png 2x" /></a></dtamazon></div> | |||
__TOC__ | __TOC__ | ||
=====Description===== | =====Description===== | ||
[https://en.wikipedia.org/wiki/Punch_(tool)#Centre '''Centre Punches'''] are ground to a strong point with an included angle of 90 degrees ''(in a similar manner to a '''[[ | |||
[https://en.wikipedia.org/wiki/Punch_(tool)#Centre '''Centre Punches'''] are ground to a strong point with an included angle of 90 degrees by holding them '''[[Tangents and Normals|Tangentially]]''' to a '''[[Tool Grinder]]''' and rotating them. This tends to create grinding marks which run along the point and strengthen it rather than weakening it by going across ''(i.e. in a similar manner to a '''[[Scriber]]''')''. | |||
=====Features and Uses===== | =====Features and Uses===== | ||
To stop a drill bit skidding about a metal surface, these are used to make a small indentation to locate the drill centre. | To stop a drill bit skidding about a metal surface, these are used to make a small indentation to locate the drill centre. | ||
---- | ---- | ||
| Line 13: | Line 17: | ||
---- | ---- | ||
{{Centre Punch Buyers Guide}} | |||
{ | |||
[[Category:Punches]] | [[Category:Punches]] | ||
Latest revision as of 14:08, 7 November 2017
Description
Centre Punches are ground to a strong point with an included angle of 90 degrees by holding them Tangentially to a Tool Grinder and rotating them. This tends to create grinding marks which run along the point and strengthen it rather than weakening it by going across (i.e. in a similar manner to a Scriber).
Features and Uses
To stop a drill bit skidding about a metal surface, these are used to make a small indentation to locate the drill centre.
Note: Hold the punch to an angle to position on centre then raise to the vertical and strike it sharply with a hammer - but only once - striking several times may cause the punch to bounce around.
- The lowest cost option is to use a hand-held punch with a hammer but a wide range of automatic punches are available - both Dot Punches and Centre Punches.
- In general, Dot Punches have a sharper point (i.e. 60° instead of 90°) and need only the lower ranges of impact force (e.g. 20N to 50N).
- Automatic punches are simply pushed down against the work-piece and do not need to be struck - indeed, should NOT be struck with a hammer.
|
|
|
|
|
|
|
| Centre Punch
|
Automatic Centre Punch
|
Bell Centre Punch
|
Nail Punch
|
Pin Punch
|
Hollow Punch Set
|
Number and Letter Punch Set
|