Centre Punch
From DT Online
Description
Centre Punches are ground to a strong point with an included angle of 90 degrees (in a similar manner to a Scriber).
Features and Uses
To stop a drill bit skidding about a metal surface, these are used to make a small indentation to locate the drill centre.
Note: Hold the punch to an angle to position on centre then raise to the vertical and strike it sharply with a hammer - but only once - striking several times may cause the punch to bounce around.
DT Online Buyers' Guide
- All punches shown have a good knurled grip.
- Those with a square head are less likely to roll off the bench.
 
|
 
|
 
|
 
|
| Stanley Centre Punch 0 58 120
|
Draper 84456 4mmx100mm Centre Punch
|
Starrett 117D Centre Punch with Round Shank
|
Spear & Jackson 4mm x 100mm (4inch) Centre Punch
|