Trimming and Cutting Card
From DT Online
Description
Use a sharp knife against a steel Safety Ruler on a Cutting Mat whenever possible. Blunt blades do not cut properly and take too much pushing through the material.
Keep fingers always behind the cutting edge and don't press too hard. Several gentle shallow cuts into card will often produce better results than attempting one heavy cut.
Safety Point! Always use a Craft Knife together with a Safety Ruler and Cutting Mat to protect fingers and table tops.
Note: Scissors can be used for paper and thin card but will tend to distort heavier card. A good sharp knife is usually best. Replace blades often and test for sharpness by cutting scrap paper.
Cutting Curves and Circles
Curves and circles can be cut using a Compass Cutter
|
 
|
|
 
|
 
|
|
|
|
|
|
|
|
|
|
|
| A3 Landscape Sketch Pad
|
A4 File Paper
|
Squared Pattern Tracing Paper
|
A3 Graph Pad
|
Coloured Card
|
A2 White Card
|
A1 White Cartridge Card
|
A2 Kraft Card
|
Grey Board
|
A2 Mount Board
|
Corrugated Card
|