From DT Online
Vices for woodworking are usually fixed to the underside of the bench top such that the metal parts lie a little below it. This prevents contact with sharp edge woodworking tools to avoid blunting them.
Features and Applications
The jaws are lined with wood facings to protect work and these extend above the metal parts to become flush with the bench top. Best practice would ensure the wood Grain runs vertically, to avoid facings splitting off under pressure, topped with a lipping to stop End Grain of facings splitting out when planing work held close to the vice.
Some vices have a quick release and adjustable ‘dogs’ which can be raised above the jaws to enable the vice to be used for cramping large pieces of work against opposing ‘dogs’ set into the bench top.
Clamp-on portable versions are also available. These too should normally be faced with timber but some are available with plastic jaws.
|Professional Quick-Release Wood Vice||Woodworking Vice with Table Clamp||Multi Angle Hobby Vice||Draper Frame Clamp Set||Stanley 083100 Band-Clamp||Corner Clamp||Fretsaw board with clamp||Precision Mitre Box||Bench Hook|