CentreDrill.png: Difference between revisions
From DT Online
(Centre Drill) |
(Added Template) |
||
| (8 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
Centre Drill | |||
{{Centre Drill Buyers Guide}} | |||
[[Category:Drilling and Boring]] | |||
Latest revision as of 16:56, 14 May 2016
Centre Drills (aka Slocombe Drills) were designed to provide a location for a Tailstock Centre (hence their 60deg point angle) but are commonly used to make a small starting indentation to guide further drilling in a Lathe.
- If used only to start a drilled hole then one or two of the mid-range sizes will suffice since it is only the tip of the Centre Drill that will be used.
- Choose only those made from good quality High Speed Steel and offer them carefully up to the workpiece whilst it is rotating since the smaller sizes in particular, can break easily.
 
|
| Slocombe Centre Drill
|
File history
Click on a date/time to view the file as it appeared at that time.
| Date/Time | Thumbnail | Dimensions | User | Comment | |
|---|---|---|---|---|---|
| current | 15:37, 10 May 2016 |  | 265 × 236 (11 KB) | DT Online (talk | contribs) | Reverted to version as of 21:12, 25 October 2015 |
You cannot overwrite this file.
File usage
There are no pages that use this file.
