Face Side and Face Edge: Difference between revisions
From DT Online
(Created Article) |
m (Added link) |
||
| Line 6: | Line 6: | ||
Throughout any subsequent marking and measuring, the '''Face Side''' and '''Face Edge''' are used as the '''Datum Surfaces''' from which all measurement are taken and against which the stock of a tool such as a '''[[Try Square]]''' or '''[[Gauges|Marking Gauge]]''' is pressed. | Throughout any subsequent marking and measuring, the '''Face Side''' and '''Face Edge''' are used as the [https://en.wikipedia.org/wiki/Datum_reference '''Datum Surfaces'''] from which all measurement are taken and against which the stock of a tool such as a '''[[Try Square]]''' or '''[[Gauges|Marking Gauge]]''' is pressed. | ||
---- | ---- | ||
<span style="color: green">'''Note:''' | <span style="color: green">'''Note:''' | ||
| Line 12: | Line 12: | ||
</span> | </span> | ||
---- | ---- | ||
[[Category:Terminology]] | |||
Revision as of 13:05, 22 July 2015
Modern timber is machined to a high degree of accuracy but this was not always the case. Even now, a length of timber might have one edge which has been cut straight and another which still retains the outside shape of the tree - known as a Waney Edge.
Good practice when marking out timber therefore is to choose the straightest edge and mark this as the Face Edge. Similarly, select the best or flattest surface and mark this as the Face Side as shown.
Throughout any subsequent marking and measuring, the Face Side and Face Edge are used as the Datum Surfaces from which all measurement are taken and against which the stock of a tool such as a Try Square or Marking Gauge is pressed.
Note: Even when Squaring Round (i.e. marking a line all around a piece of timber) a Try Square stock should always be pressed against either the Face Side or Face Edge