Actions

Slopes and Angles in Perspective

From DT Online

Revision as of 14:01, 5 July 2016 by DT Online (talk | contribs) (Added Template)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

In most drawing projections, it is possible to draw only vertical and horizontal lines directly. Any sloping surface have to be drawn by joining together two end points which have been constructed by intersecting a vertical and horizontal line

Slopingroofs.png



Construction

Look carefully at the red lines - these are drawn in perspective as if the house was completely cuboid. One way of thinking about it is to imagine that what you are drawing is packed inside a close fitting box and you draw the boxes first.


Slopingroof2.png


Once these 'boxes' or 'crates' have been drawn it is possible, using additional lines, to identify points on their edges which define the ends of the roof slope.


Note: The technique of drawing complex objects in 3D by first imagining they are packed inside tight-fitting boxes or crates is sometimes called 'crating'.


Step by Step Construction
ObliquePerspective2.gif

Step 1

The first task is to draw the imaginary close-fitting 'box' or 'crate' that would contain the object you wish to draw.. Using Single Point Perspective this is done simply by starting with a square or rectangle then projecting back to a suitable Central Vanishing Point (CVP).


ObliquePerspective3.gif

Step 2

Next draw another square or rectangle within the projection lines.


Note: The second square or rectangle will be a Similar Figure to the first and, in Single Point Perspective sides of the figures remain vertical or horizontal.


ObliquePerspective6.gif

Step 3

Any slopes or angles required can now be drawn directly on the end face of the object and projected back to the CVP to locate points on the rear face.


ObliquePerspective7.gif

Step 4

Next 'line in' the required outline of the object.


Note: Oblique projections such as Single Point Perspective, are particularly useful when drawing objects that have a complex cross section but are relatively plain other respects - such as extruded or moulded sections.


ObliquePerspective8.gif

Step 5

Finally, shading or rendering will complete the drawing.



DT Online Buyers' Guide
A3 Cartridge Paper A3 Layout Pad A3 Marker Pad A3 Coloured Pad A3 Tracing Paper A3 Graph Pad A3 Drawing Board Drawing and Sketching Pencil Art Set Coloured Pencil Set A3 Light Box
A3 Cartridge Paper A3 Layout Pad A3 Marker Pad A3 Coloured Pad A3 Tracing Paper A3 Graph Pad A3 Drawing Board Drawing and Sketching Pencil Art Set Coloured Pencil Set A3 Light Box