Actions

Two Point Perspective

From DT Online

Revision as of 14:04, 5 July 2016 by DT Online (talk | contribs) (Added Template)
(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)

This is a form of Angular Perspective, it is the perspective view when looking at something at an angle to you. It is very useful for representing the outside of buildings and 3D products.


2point.png


Angular or Two Point Perspective is used when the object to be drawn is positioned at an angle to the viewer. The first line to be drawn is the vertical front edge of the object on which heights can be marked. These points are then projected back to two separate Vanishing Points which are usually imagined to be lying on the horizon.


2point2.png

Look carefully at the red lines - the vertical front corner of the building was drawn first, then the lines that go back into the picture were projected until they crossed - or intersected.


The two points where the projected lines cross are called Vanishing Points and, as a check on drawing accuracy they should normally be opposite each other on the same horizontal Eye Line


Note: The height at which the Eye Line, or Horizon Line, passes across the front corner of the building provide a clue about the viewing position - in this example it can be deduced that someone of normal height took the photograph standing on the road or pavement.


Step by Step Construction
2pt1.gif

Start by drawing an Horizon or Eye Line and mark on it two Vanishing Points - these can be anywhere but position them as wide apart as possible to start with.


2pt2.gif

Next draw in the front edge of the object you wish to draw and project back to the two Vanishing Points, VP1 and VP2.


Note: If the front edge is positioned below the Horizon you will see the top of it, as if looking from above.


2pt3.gif

Make a judgement about the length of each side and project the rear corners back to the Vanishing Points - all vertical lines remain vertical.


Note: The further apart the Vanishing Points are, the more realistic the image, but placing them close together can produce interesting and dramatic 'fish eye' type views.


2pt4.gif

Finally, line in the completed outline and apply shading or colour if required - keep the top surface white and use two different tones for the sides to indicate the direction of light.



DT Online Buyers' Guide
A3 Cartridge Paper A3 Layout Pad A3 Marker Pad A3 Coloured Pad A3 Tracing Paper A3 Graph Pad A3 Drawing Board Drawing and Sketching Pencil Art Set Coloured Pencil Set A3 Light Box
A3 Cartridge Paper A3 Layout Pad A3 Marker Pad A3 Coloured Pad A3 Tracing Paper A3 Graph Pad A3 Drawing Board Drawing and Sketching Pencil Art Set Coloured Pencil Set A3 Light Box